6 Options6-28FrameSaver NP 110 User’s Manual - Installation Guide 980-001-0240BNovember 2000ParameterSettingThis section describes the additional screens and parameters used to configure theISDN Adapter option. There are also some field changes on the System View Screenspecific to the ISDN Adapter option. The ISDN configuration screens are: ISDNAdapter Configuration Screen and the Backup/On-Demand Configuration Screen. Allbasic unit screens are described in Section 4, “Operation,” in this manual.System ViewScreenThe System View screen for FrameSaver NP 110 with ISDN Adapter is shown in Fig-ure 6-16.Figure 6-16 System View Screen with ISDN Adapter OptionThe ISDN-specific fields on the System View screen are as follows:Active S/W: Revision of the software currently operating the base unit (active flashmemory).Idle S/W: Revision of the software currently in the offline flash memory. If the soft-ware in the Idle Flash is not usable, the field indicates “FlashFail.”NOTE: For both Active and Idle software, the first two-digit number indicates theunit’s product phase, the second indicates the major software revision, and the lastindicates minor revision level. Alpha characters at the end of the field indicate theoption type installed.The example shown in Figure 6-16 above indicates the unit has an ISDN Adapterinstalled (i=ISDN).*********************** FrameSaver NP 110 - System View ************************Name: F@43802 Active S/W:03.01.30iLocation: Fair Lawn, N.J. Idle:A S/W:03.01.20iContact: J. Jones Base S/N:002431System Test/Fault: User Ckt StatusNetw Port Fault: RTS/DTR/LL/Pwr: On /On /Off/OnDevice Fault: Frame Fault:Active Test: ISDN:Modem Status On-Demand Port StatusFault: RTS/DTR: On /OnConnection: ISDN:Aux Port StatusAux1 DTR: OnAux2 DTR: OnDevConfig[DC] CsuConfig[CC] FrameConfig[FC] PvcConfig[PC] MonConfig[MC]DevTest[DT] CsuStats[CS] FrameStats[FS] PvcStats[PS] MonStats[MS]SnmpConfig[SC] TrapConfig[TC] IsdnConfig[IC] BkupConfig[BC] IsdnTest[IT]Help[?] Logout[LO] AutoUpdate[AU] TopStats[TS] HubConfig[HC]>
