4 Operation4-14FrameSaver NP 110 User’s Manual - Installation Guide 980-001-0240BNovember 2000Frame ManagerConfigurationThe Frame Manager Configuration screen allows you to view and alter parameters forFrame Manager operations.The Frame Manager Configuration screen is shown in Figure 4-5.Figure 4-5 Frame Manager Configuration Screen1. WAN Mgmt DLCI - Displays the current DLCI value of the private network PVCor Tunneled PVC for WAN management of the FrameSaver NP 110, as stored inthe unit’s non-volatile memory (NVM). Enter the DLCI number only, for privatenetwork PVC. Preface the DLCI number with “T” for tunneled PVC. Preface theDLCI number with “D” to have the WAN Mgmt IP Address relearned each timethe PVC returns to an “active” condition.2. P/C Mgmt DLCI - Sets or disables the direction and PVC for Payload/CPEmanagement access to the FrameSaver NP 110. The first letter (P or C) determineswhich direction, and the remainder indicates the DLCI value.NOTE: The P/C Mgmt DLCI value must NOT be the same as WAN Mgmt DLCI.CAUTIONIf either WAN or P/C Mgmt DLCI value is changed, theFrameSaver NP 110 will perform a system reset after theSave [SA] command is issued. The system reset willterminate any console session in progress and interruptdata traffic.3. LMI Protocol - Displays and allows the selection of the LMI protocol used. If setto “None,” LMI traffic (if any) to or from the Network will be passed through theFrameSaver NP unaffected, and the unit’s LMI alarms and status will be cleared.4. Network (DTE) - Consists of the settings required for the various protocols. Theseinclude T391, N392, N393 and N391.************************** Frame Manager Configuration *************************Name: F@43802LMI Protocol [P=]WAN Mgmt DLCI [D=#,T#orD#]: Disabled 1) None 3) "LMI"P/C Mgmt DLCI [E=P#orC#]: Disabled >>2) ANSI"D" << 4) ITU"A"X to Disable or 16 thru 991------------- Network ------------ -------------- User --------------T391/Status Enq Rate [S1=#]: 10 T392/Status Enq Timeout [S2=#]: 155 thru 30 seconds 5 thru 30 secondsN392/Event Err Thres [T1=#]: 3 N392/Event Error Thres [T2=#]: 3N393/Event Count [C1=#]: 4 N393/Event Count [C2=#]: 41 thru 10 1 thru 10N391/Full Status Freq [F1=#]: 6 Force Full Status Response [F2=]1 thru 255 >>1) Disable<<2) EnablePVC BECN/FECN Thres [B=#]: DisabledX to Disable or 1 thru 895 secondsLink Err Thres [L1=#]: Disabled Link Err Thres [L2=#]: DisabledX to Disable or 1 thru 895 seconds X to Disable or 1 thru 895 secondsHelp[?] Save[SA] Cancel[X]>
