4 Operation4-12FrameSaver NP 110 User’s Manual - Installation Guide 980-001-0240BNovember 2000CSU / InterfaceConfigurationThe CSU / Interface Configuration screen allows you to view and alter parameters forthe CSU and CPE interface operations.Figure 4-4 shows the CSU / Interface Configuration screen.Figure 4-4 CSU / Interface Configuration Screen1. Name - Device’s ID as defined in unit’s Device Configuration.2. Page - Shows the page number of the displayed page. When the DSX/Dropoption adapter module is present, page 2 may be selected to configure settings forthe option module. Refer to section 6 “Options” of this manual for DSX/Dropsettings.DS0 Assignments - Shows the assignment of the DS0s (time-slots) to the unit's UserPort with an "X" in the DS0s column location.3. User - Defines which DS0s will be allocated to the User port.All the DS0s for a port are entered with a single command. The DS0 numbers maybe entered: separately with a "comma" between each number, as a range with a"dash" between the start and end numbers, or a combination of both formats. Forexample, any of the following commands will result in DS0s 1 through 8 beingassigned to the User Port.U=1,2,3,4,5,6,7,8 or U=1-8 or U=1,2,3,4-8Entering a blank for a port command will clear all assignments for that port.************************* CSU / Interface Configuration ************************Name: F@43802Page [P=#]: 1 of 1----------- DSO Assignments ---------- ------- Network Port Settings ------111111111122222123456789012345678901234 Facility ID [I=]: NONAMEUser [U=]: XXXXXXXXXXXXXXXXXXXXXXXXBuild Out [B1=] Framing [T1=]>>1) T1-0<< >>1) ANSI<<2) T1-7 2) AT&T([U=m,n,..r] and/or [U=m-n] for multiples) 3) T1-15 3) SF4) T1-22--------- User Port Settings ---------- Clock Source [S=]Ones Dens [D1=] >>1) Network<<Data Rate: 1536 Kbs >>1) B8ZS<< 2) Internal2) AMIDS0 Format [F1=] Port TxD Clk [C1=]1) Nx56 kbs >>1) DCE<< Link Err Thres [L1=#]: Disabled>>2) Nx64 kbs<< 2) DTE X to Disable or 1 thru 895 secondsHelp[?] Save[SA] Cancel[X]>
