6 Options6-32FrameSaver NP 110 User’s Manual - Installation Guide 980-001-0240BNovember 2000Backup / On-DemandConfigurationThe Backup / On-Demand Configuration screen allows you to view and alter parame-ters for the ISDN Backup or On-Demand operations.To proceed to Backup/On-Demand Configuration, from the System View Screen, type“BC” and press ENTER.The Backup / On-Demand Configuration screen is shown in Figure 6-18.Figure 6-18 Backup / ON-Demand Configuration ScreenBackup: Establishes an ISDN data link and switches the Base module Frame Managerfrom the T1 link onto the ISDN link(s). Backup is triggered by a T1 outage, loss ofNetwork or may be operator-initiated. Configuration items are:Bkp # n WAN IP Add - Sets the IP Address for management access while theunit is on backup. Bkp # 1 WAN IP Add is used for Primary Dial # 1, and Bkp #2 WAN IP Add is used for Secondary Dial # 2.Bkp Activate Delay - Sets the time to wait after a T1 outage or loss of Networkis detected, before a backup attempt is initiated. Valid range is from 0 to 240 min-utes.NOTE: If the original initiating condition clears for a duration of at least oneminute and the Bkp Activate Delay has not yet expired, the backup will beaborted.Bkp Rtry Count - Sets the number of retry attempts to establish a backup connec-tion on each set of phone #’s (Primary then Secondary). Valid range is from 1 to 4.Bkp Rtry Holdoff - Defines the delay between each retry attempt. Valid range isfrom 1 to 15 minutes.*********************** Backup / On-Demand Configuration ***********************Name: F@43802 Bkp Downspeed Minimum [M1=#]: 1Bkp#1 WAN IP Add [I1=]: 0.0.0.0 Dmd Downspeed Minimum [M2=#]: 1Bkp#2 WAN IP Add [I2=]: 0.0.0.0 1 thru 8 channelsBkp Activate Delay [A=#]: 1 Dmd LMI Holdoff [N=#]: 00 thru 240 mins 0 thru 15 minutesBkp Rtry Count [C1=#]: 1 Learn IP Add [L=] Dmd Rtry Count [C2=#]: 11 thru 4 >>1) Each Connect<< 1 thru 4Bkp Rtry Holdoff [H1=#]: 2 2) When Zero Dmd Rtry Holdoff [H2=#]: 21 thru 15 minutes 1 thru 15 minutesAssign to Backup [B=]/Demand [D=] ([B=m,n,..r] and/or [B=m-n] for multiples)-Channel- -Assign- ----- Primary Dial #1 ---- ---- Secondary Dial #2 --->>1) Line1 B1 Backup<< [P1=]: [S1=]:>>2) B2 Backup<< [P2=]: [S2=]:>>3) Line2 B1 Backup<< [P3=]: [S3=]:>>4) B2 Backup<< [P4=]: [S4=]:>>5) Line3 B1 Demand<< [P5=]: [S5=]:>>6) B2 Demand<< [P6=]: [S6=]:7) Line4 B1 [P7=]: [S7=]:8) B2 [P8=]: [S8=]:Help[?] Save[SA] Cancel[X]>
