Appendix B: Accessing a Paragon II from the KX III410Supported Connection Distances Between Paragon II and KX IIIWhen using KX III as the front end of a Paragon II system, you shouldrestrict the cable length (distance) for good video quality.Supported distance from the Paragon II user station to the target serveris 500 cable feet (152 m). Greater distances may result in videoperformance that may or may not be acceptable to you.Supported distance from KX III to the Paragon II user station is up to 150cable feet (45 m).Connecting the Paragon II to the KX IIITo connect the Paragon II system to a KX III:1. Check whether the Paragon II user station that you want to connectto the KX III is implemented with version 4.6 firmware (or later). Ifnot, upgrade it.The Paragon II user station can be one of these: P2-UST P2-EUST P2-EUST/CSee Paragon II Help for information on upgrading.2. Plug a compatible DCIM-USB into the USB and video ports on theParagon II user station.If the system is a two- or three-tier system, ensure the Paragon IIuser station is connected to the base KX III device (first tier).3. Connect the Paragon II user station to a KX III device via a Cat5 UTPcable up to 150 feet (45 m). Plug one end of the cable to the DCIM's RJ-45 port and the otherend to one of the channel ports on the KX III device.4. If you want to have more paths to access the same Paragon II systemin KX III or CC-SG, repeat Steps 1 to 3 to connect additional userstations to the KX III.
