DT Etherlink IV User Manual- 43 -4 PROGRAMMING GUIDE4.1 Command StructureMain MenuPM Performancemanagement FMM Fault and maintenancemanagement CM ConfigurationmanagementAPPLY [ALL/GROUP] NM AUTO [ON/OFF]G826 STATUS CONFIGG826 C STATUS T CONFIG [N/R/S/B]G826 E1 STATUS L MASTER [ON/OFF] [N]G826 E1 C STATUS ETH EXT [ON/OFF] [N]ALLG826 N STATUS EXT BASERATE [N/AUTO] [M]RESETG826 LOOP1 [ON/OFF] [N] PAM [16/32] [N]RESETALLG826 N LOOP2 [N:[A/R]] [ON/OFF] PAYLOAD [list] [N]NETSTAT [LAN/WAN] ALARM ANNEX [A,B,A/B] [N]NETERR [LAN/WAN] ALARM T SETCLOCK [list] [N]RESETNETSTAT ACO MULTIPAIR [2/3/4/2+2/OFF]LINKSTAT ACO [GROUP] [ON/OFF] RESERVE [list1] {list2}LINKALARM MACTABLE C G704 [ON/OFF] [N]ALARMLOG [N] MACTABLE [1-8/OTHER/Port] CRC4 [ON/OFF] [N]ALARMLOG C MACTABLE AISDET [ON/OFF] [N]CONNECT [N:[1-13/R]] STARTAL [N] AISGEN [ON/OFF] [N]LINK [NN] RESTART [N] DSLTS [list] [N]LINKCLEAR RESET WANTS [list] [N]M(AIN) APPLY [ALL/GROUP] E1CLOCK [DSL/RX/EXT] [N]H(ELP) CONFIRM E1MODE [HDB3/AMI] [N]BACKUP PASSWORD [USER/ADMIN]RESTORE ID stringDIFF [N/R/S/B] [N/R/S/B] RESPONSE [NN/OFF]DUMP [N/R/S/B] DEFAULT [0-4]LOAD DEFAULT EVERYTHINGTLM SERNUMTLM D APPLY [ALL/GROUP]TLM S [N:Rnn-Rkk] [ABC] GSCOMPAT [ON/OFF]TLM C NMTHR [N/OFF]CONNECT [N:[1-13/R]] LATHR [N/OFF]LINK [NN] PTMP [ADD|DEL] [IF]LINKCLEAR PTMP SHOWSOFTUPDATE MODE [N]TFTP [CMD] [ARG1][ARG2] LICENSESOFTCONFIRM LICENSE ADD [key]SOFTINFO CONNECT [N:[1-13/R]]PING x.x.x.x LINK [NN]M(AIN) LINKCLEARH(ELP) RSFORMAT [Format]RSDUPLEX [F/H]EXTRATE [N]AUTOLOOP OFF/ALL/DATAEXTCLOCK [SRC] [DIR]NET ▬▬► APPLY [ALL/GROUP]M(AIN) LINK [NN]H(ELP) LINKCLEARNETCONFIGNETCONFIG [N/R/S/B]COSCONFIGCOSCONFIG [N/R/S/B]RSTP DEFAULTRSTP [CONF/STATE]RSTP [BR/IF] [OPT] [N]RSTP [A..E] [ON/OFF]PBVLAN [IF] [A..E]MODE [IF] [ACC/TRUNK/MIX]VLAN [IF] [1..8]QOS [IF] [0..7]ALLOW [IF] [VLAN list]VID [1-8] IDSETIP x.x.x.xGATEWAY x.x.x.xNETMASK x.x.x.xMTU [68..1500]WANIDLE [1/7E]ETHSD [MODE] [N=1-4]
