|
DT Etherlink IV User Manual- 81 -4.6.5.54 CommandThis command sets default VLAN number for interfaces in ACCESS or MIXED mode ([IF] is LANx,INT). Default VLAN is used to assign VLAN information for untagged traffic.In ACCESS mode, only frames with VLAN equal to port's default VLAN are allowed to egress.In MIXED mode, frames with VLAN equal to port's default VLAN egress untagged. Frames of alother VLANs are blocked or are allowed to egress tagged according to rules set by ALLOWcommand.In both ACCESS and MIXED modes ingressing untagged frames are assigned to default VLAN.There are 8 separately managed VLANs in the modem. For each managed VLAN the VID (VLANID) can be selected with the VID command.4.6.5.55 CommandThis command sets default QoS for interfaces in ACCESS or MIXED mode ([IF] is LANx, INT). TheLowest priority is 0, the highest is 7. Default QoS is used to assign quality of service information foringressing untagged traffic.The INT interface is always considered in ACCESS mode and all frames coming from the INTinterface will have default QoS assigned.4.6.5.56 CommandThis command selects which VLANs are allowed on interfaces in TRUNK or MIXED mode ([IF] isLANx, WANx).The VLAN list is a comma-separated list of allowed VLANS from 1 to 8, and the word OTHER(allows all other VLANs except 1-8). Spaces in the list are not allowed. To allow all VLANS on theinterface, write ALL in the list.CP_NET>ALLOW LAN1 1,2,3CP_NET>ALLOW WAN2 5,3,OTHERCP_NET>ALLOW WAN4 ALL4.6.5.57 CommandThe command sets VID for the VLAN with the number 1..8 equal to the IDparameter. ID=1...4094. 8 VLANs are supported by the device, and available VID numbers assignedto the VLAN are in the range from 1 to 4094. VID as well as QoS are an attribute of the VLANpacket.4.6.5.58 CommandThe command sets the IP-address of the modem. The parameter A, B, C and Dcan take values from 0 to 255 (note that neither address of the network nor the address of the nodecan be equal to 0, or to 255).4.6.5.59 CommandThe command sets the subnet mask of the modem.4.6.5.60 CommandThe sets the default IP address of the router.
|
