S-Access ETHERLINK IV Technical Description And Operations Manual

Contents

Table Of Contents
Table Of Contents
Table Of Contents
Table Of Contents
VERSION CONTROL
SELECTION GUIDE
PRECAUTION
TECHNICAL DESCRIPTION
Description of Etherlink_IV NTU Devices
Remote Power Supply and Wetting Current
Configuration of Remote Power
Description of Etherlink_IV Interfaces
Master/Slave
Reservation Mode
Automatic Configuration of a Link
E1 Interface (G.703/704)
AIS Detection
Nx64 and RS-232/RS-485 Interfaces
MASTER
Automatic V.54 Loops
Rapid Spanning Tree Protocol
An Integrated Switch of 64-kbit/s Time Slots
Test Loops
Analogue Loop back
BERT Test
Alarm Indication
Alarm LEDs
Management of Etherlink_IV Devices
Management by Ethernet Interface
SNMP
PROGRAMMING GUIDE
Etherlink_IV Software
Groups of Commands Requiring Confirmation
Commands
General Commands
Performance Management Menu
ALLG826 N> Command
NETERR [LAN/WAN]> Command
RESETNETSTAT> Command
M> Command
Fault and Maintenance Management Menu
STATUS> Command
STATUS ETH> Command
AСO [GROUP ON/OFF])> Command
MACTABLE> Command
RESTART [N=1..4]> Command
DUMP N/R/S/B> Command
TLM> Command
SOFTUPDATE> Command
SOFTCONFIRM> Command
Configuration Management Menu
CONFIG / N / R / S / B > Command
MASTER ON/OFF [N = 1..4]> Command
PAM [16/32] [N]> or <PAM [4-128] [N]> Command
MULTIPAIR [2/3/4/2+2/OFF]> Command
DSLTS list/NONE [N=1..4]> Command
DEFAULT EVERYTHING> Command
MODE N> Command
EXTCLOCK [SRC] [DIR]> Command
COSCONFIG [N/R/S/B]> Command
RSTP [A..E] [ON/OFF]> Command
RSTP [IFACE] PCOST [AUTO/1..200000000]> Command
RSTP STATE> Command
MODE [IF] [ACC/TRUNK/MIX]> Command
VLAN [IF] [1..8]> Command
MTU> Command
TRAPIP [ADD/DEL] X.X.X.X> Command
user manual
Software Download via RS-232, USB Port (LCT) Using the Flash Loader Program
Software Download via RS-232, USB COM Port (LCT) Using Xmodem Protocol
Software Download via Ethernet (1K-Xmodem and Telnet)
General Requirements
Quick Installation Guide for Etherlink_IV NTU Devices
Checking of Correct Working
Connector Description
Nx64 and RS-232 Connector
Monitor (LCT, Local Craft Terminal) Connector
Interfaces
Alarm at Local Craft Terminal (RS-232) Interface
Physical Dimensions and Weight

S-Access ETHERLINK IV Technical Description And Operations Manual Manual pdf 90 page image

DT Etherlink IV User Manual- 90 -5.2 Software Download via RS-232, USB COM Port (LCT) Using Xmodem ProtocolTo download the software on any Etherlink_IV device, do the following steps:1. Power on the device.2. Connect the RS-232 connector of the device (Monitor, LCT) with the Com port (RS-232) of thePersonal Computer.3. Run the Hyper Terminal program (hypertrm.exe).4. Create a new connection in the “Connection Description” window. Input the name of theconnection in the “Name” field. Click “Ok”.5. Then the “Connect To” window is displayed. Select the COM port connected to the subrack,minirack or DESKTOPx in the “Connect Using” drop-down menu. Click “Ok”.

/ 107

This manual is suitable for:

ETHERLINK IV

manualsdatabase

Your AI-powered manual search engine