|
DT Etherlink IV User Manual- 58 -AIS-S : off off SEGD : off offAIS-R : off off BER-H : off offLOOP1 : off off ALB : off offBER-S : off off SEGA : off offLOOP2 : off offRCONF : off off--------------------------------------------------------------------------------Ethernet Maintenance--------------------------------------------------------------------------------LOS-E : on HW-F : offDSL-F : off--------------------------------------------------------------------------------CO_FMM>Option: T – enable the continuous updating of the table with actual alarm status.Definitions (Nx64 interface)ECA Cable is not connectedDTR-OFF DTE is inactiveLOOP1 A loop is activated on the network interface in the direction of the Е1 equipmentTable 4.3 definitions4.6.4.9 CommandThe command (Alarm Cut Off) without additional parameter shows deactivated alarmindications (LED and relays).CO_FMM>ACOETH1, ETH2, ETH3, ETH4CO_FMM>The command activates/deactivates a GROUP for alarm indications.Definitions (E1 interface)LOS-S Loss of signal on the Е1 sideLFA-S Loss of frame alignment on the E1 sideAIS-S Receiving AIS on the E1 sideAIS-R Receiving AIS on the E1 side by a remote deviceBER-S The block error rate on the Е1 side exceeded the admissible valueLOOP1 A loop is activated on the network interface in the direction of the Е1 equipmentDefinitions (Ethernet)LOS-E Loss of signal on the Ethernet interfaceDefinitions (SHDSL)LOS Loss of signal in SHDSLLOSW Loss of signal or frame alignment in SHDSL (loss wire)SEGD A failure in the line (segment degradation)BER-H The block error rate in the line is according to G.826 30%ALB Analogue loop back is activeSEGA Errored data or errored frame alignment (segment alarm)NM Noise Margin < NM thresholdLA Loop Attenuation > LA thresholdLOOP2 A loop is activated on the line interface of a remote device in the direction of the local deviceRCONF Configuration of the remote device is not compatible with the configuration of the local device(for example, the local device is configured to transmit Ethernet data, while the remote deviceis configured to transmit two E1 streams)Definitions (Maintenance):HW-F Hardware failureDSL-F DSL failure
|
