|
DT Etherlink IV User Manual- 72 - The DEFAULT 0 command sets the following mode: SLAVE, PAM 32, BASERATE 89,ANNEX B, transmission of the E1 stream and Ethernet over SHDSL. The DEFAULT 1 command sets the following mode: MASTER, PAM 32, BASERATE 89,ANNEX B, transmission of the E1 stream and Ethernet over SHDSL. The DEFAULT 2 command sets the following mode: SLAVE, PAM 32, BASERATE AUTO,ANNEX A/B, transmission of the E1 stream and Ethernet over SHDSL. The DEFAULT 3 command sets the following mode: MASTER, PAM 32, BASERATE 89,ANNEX B, transmission of the 2xE1 stream and Ethernet over SHDSL.4.6.5.23 CommandThis command sets default operation modes for line parameters (see the DEFAULT command) andfor network parameters (see the command). The result of this command is similarto the result of two commands:DEFAULT 0NETDEFAULT4.6.5.24 CommandThis command shows the production serial number of the unit.4.6.5.25 CommandThis command sets the Globespan (Conexant) compatibility mode on/off. This feature will also limitthe baserate to 36 (PAM16).4.6.5.26 CommandThe command allows to setup the desired Noise Margin alarm threshold in dB.Syntax: NMTHR [value], where value is in the range from 0...25NMTHR OFF disables the Noise Margin alarm threshold function4.6.5.27 CommandThe command allows to setup the desired Line Attenuation alarm threshold in dB.Syntax: LATHR [value], where value is in the range from 0...25LATHR OFF disables the Line Attenuation alarm threshold function4.6.5.28 CommandThis command helps to add or delete an interface to the Point-to-Multipoint group channel.[IF] is the name of interface to add or delete: RS-1: RS-232 or RS-485 WAN1-WAN4: WAN interface to transmit PTMP data through DSL1-DSL4: DSL interface transmitting WANDSL and E1 interface names are automatically converted to corresponding WAN channels by thiscommand.4.6.5.29 CommandThis command shows the members of the Point-to-Multipoint group channels.
|
