DT Etherlink IV User Manual- 76 -System settings :MAC address : 00:0f:d9:04:a9:00IP address : 192.168.0.235Subnet mask : 255.255.255.0Default gateway : 0.255.255.255--------------------------------------------------------------------------------Warning: New network configuration differs from running network configuration!To view new network configuration, type 'NETCONFIG N'To view running network configuration, type 'NETCONFIG R'To apply changes in configuration, type 'APPLY VLAN' or 'APPLY ALL'.Do not forget to 'CONFIRM' a good working configuration.CP_NET>The [N/R/S/B]> command displays one of four configurations: New, Running,Startup, or Backup, depending on the parameter.When a command used to change the configuration of the VLAN or network is successful, the newconfiguration is applied similarly to the command. This is determined by the factthat configurations of the group VLAN or NET, which require confirmation, will not be displayed inthe running configuration, but will be changed only in the new configuration.4.6.5.41 CommandWithout parameters the command displays the running CoS configuration:CO_NET>COSCONFIG--------------------------------------------------------------------------------Running QoS Configuration--------------------------------------------------------------------------------QoS to CoS mapping Per-VLAN CoS override--------------------- ---------------------QoS : 0 1 2 3 4 5 6 7 VLAN: 1 2 3 4 5 6 7 8CoS : 3 3 3 3 3 3 3 3 CoS : - - - - - - - ----------------Rate limit--------------------Egress : WAN1 WAN2 WAN3 WAN4CoS 0 : OFF OFF OFF OFFCoS 1 : OFF OFF OFF OFFCoS 2 : OFF OFF OFF OFFCoS 3 : OFF OFF OFF OFF---------------------------------------------Ingress : LAN1 LAN2Per port: OFF OFFTotal : OFF--------------------------------------------------------------------------------CO_NET>It shows the QoS-to-CoS and VLAN-to-CoS mapping. CoS (Class of Service) as well as QoS(Quality of Service) have to be configured for a correct behaviour!The rate limits for any interface is showed too.The command displays one of four CoS configurations: New, Running,Startup, or Backup, depending on the parameter.4.6.5.42 CommandRSTP DEFAULT command restores factory settings for RSTP subsystems: All RSTP instances are disabled; modem works like it has no RSTP system. Each system interface has priority 128 (0x80) Each system interface calculates PCOST automatically Each RSTP instance has priority 32768 (0x8000) Each RSTP instance works in VLAN# 1 Hello time for each RSTP instance is 2 secondsCX_03_NET>RSTP DEFAULT
