DT Etherlink IV User Manual- 96 -7 APPENDICES7.1 Quick Installation Guide for Etherlink_IV NTU Devices7.1.1 Enter an Etherlink_IV DeviceTo enter in a subrack unit, use the Monitor (LCT, RS-232) interface with Hyper Terminal (or anyequal program) or go with Telnet through the Ethernet interface.Monitor (LCT, RS-232) Interface: Configure the COM port: Bits per second:9600, Data bits: 8, Parity: None, Stop bits: 1, Flowcontrol: None Press .Telnet through Ethernet Interface: Type in command line and press . This is the defaultEthernet Address for Etherlink_IV devices.After a successful entering the main menu of the device will be displayed.7.1.2 Configure an Etherlink_IV DeviceA first installation example with the most important commands and points to care about is shownbelow. We just like to have an Ethernet transmission between the two NTU devices over 4 SHDSLcopper pairs with a speed of 22.8Mbit/s. The pairs should aggregate (bundle) the data traffic and incase of any SHDSL pair failure, the remaining pairs should continue to work.SHDSL 4 pair EthernetEthernetMonitor (LCT)Monitor (LCT)NTU1 NTU-2
