|
DT Etherlink IV User Manual- 64 - SET: Set the TFTP protocol options. ARG1 specifies the option name and ARG2 the newvalue for this option. Following options are supported: TIMEOUT (the time the device will waitfor a reply from the TFTP server) and RETRY (the number of times the device will retry theoperation). SHOW: Show the current TFTP settings (timeout and retry)Examples: TFTP SHOW TFTP SOFTUPDATE 172.16.53.1 APP.BIN TFTP LOAD 172.16.53.1 ltu/backup_cSA.txt TFTP DUMP 172.16.53.1 ltu/current_cSA.txt TFTP SET TIMEOUT 10 TFTP SET RETRY 14.6.4.24 CommandThis command confirms the new version of the software. After downloading the new software, acounter is switched on and starts of the running software. If this software is not confirmed with thehelp of the command after the restart, it will not be valid.CO_FMM>SOFTCONFIRMSoftware confirmedCO_FMM>SOFTCONFIRMSoftware already confirmedCO_FMM>4.6.4.25 CommandThis command displays some information about the software, which are stored in the current device.Any device can have two stored software copies (different versions are possible). One copy of thesoftware is started after switching power on, while the other is a backup software.CP_FMM>SOFTINFO1: ver.: 1.1.3, date: 2.6.2006, length: 328k, CRC OK, fixed2: * ver.: 1.1.4, date: 3.7.2006, length: 330k, CRC OK, confirmedCP_FMM>The asterisk shows the running downloaded version (starts after power on).ver – The number of the software version.date – The date of the software creation.length – The size in bytes.CRC OK/FAIL – A label showing if the software is damaged or not.The software status is displayed at the end of the corresponding line:fixed – First basic software. Cannot be downloaded, does not require confirmation.just loaded – Downloaded second software.not confirmed – Non-confirmed second software.confirmed – Confirmed second software.4.6.4.26 CommandThis command will PING any remote IP address. It sends an ICMP ECHO request message andwait for the corresponding ICMP ECHO reply message. This command will not ping the own deviceIP adress.CO_FMM>PING 192.168.1.11
|
