DT Etherlink IVUser Manual- 48 -4.6.2General Commands4.6.2.1 CommandAfter the command is entered the device displays the help menu.4.6.2.2 CommandThis command is used to apply changes in all groups or to apply changes in one of these groups:LINE, VLAN, NET, and SNMP. As a result, changes in the group are written from the newconfiguration into the running one. Examples:CO_FMM>APPLYApplying all configuration changesto running configurationCO_PM>APPLY LINEApplying configuration changes in group LINE to running configuration4.6.2.3 CommandThe commands initialize the management of the remote device.Theparameter N sets the number of the SHDSL channel, over which the connection is initialized. Insingle-channel systems the parameter N can be absent.Notes:1.The command in the Slave mode is only available if the Masterdevice can be configured locally at this instant.2.The (N=1..13) command initializes the management of the remoteregenerator. The command is only available in the Master mode.3.This command is not provisioned for regenerators.4.If the channel of remote management is blocked (for example, a message or atable are not displayed completely), press Enter.4.6.2.4 CommandThe < LINK [SN/00/FE]> command establishes connection to specified unit over the backplane.SN - Specifies the slot number of a subrack unit to connect with. If the backplane is busy or if thespecified subrack slot is free (or no response in 1.5 first seconds) the "LINK ERROR" messagewill be issued by the unit. For subrack units SN should not be 00.00 - (double zero) Switches on the Monitor (Local Craft Terminal) connector control mode forMinirack and standalone units. In this mode all typed characters will be translated to the Monitorconnector.FE - (for ever) Switches on Monitor connector control mode for common CLI RS232 units. In thismode all typed characters will be translated to Monitor connector. The connection will beestablished until a terminal timeout appears.Example:LINK 10 - Establish connection to subrack unit with slot number 10.LINK 00 - Establish monitor control node.LINK FE - Establish monitor control node.Notes:To refuse link connection just exit from controllable unit.To refuse link connection urgently use CTRL+Z keystroke.4.6.2.5 CommandThe < LINKCLEAR > command closes current virtual link connections.
