DT Etherlink IV User Manual- 60 -CO_FMM>STARTAL 1Analog loopback startedCO_FMM>STARTAL 1Analog loopback stoppedCO_FMM>Note: This command is used in the Master mode. Detach the cable from the SHDSLconnector before starting the analogue loop back.4.6.4.12 CommandThis command restarts the corresponding SHDSL channel. First it causes the loss of sync betweenmodems which later will be restored. For single-channel devices the command is used without anyadditional parameters.CO_FMM>RESTART 1Restarting channel 14.6.4.13 CommandThe command restarts the device.CO_FMM>RESET4.6.4.14 CommandThis command confirms the running configuration and writes it to the startup configuration. As aresult, after confirmation of the configuration variables changes in all groups, they will be writtenfrom the running configuration into the startup configuration.CO_FMM>CONFIRMCurrent running configuration is confirmed and written tostartup configuration in EEPROM4.6.4.15 CommandThis command is used to create a backup of the running configuration of the device in theEEPROM. As a result, the running configuration is written to the backup configuration.CO_FMM>BACKUPCurrent running configuration is written tobackup configuration in EEPROMCO_FMM>4.6.4.16 CommandThis command restores the startup configuration from the backup configuration, which was stored inthe EEPROM. The modem should be restarted that restored values become valid.CO_FMM>RESTORERestored startup configuration from backup configuration.Reset modem for all changes to take effectCO_FMM>4.6.4.17 CommandThis command displays differences between up to four configurations: New, Running, Startup, orBackup.CO_FMM>DIFF R B------------------------------------------------------------------------Running configuration Backup configuration------------------------------------------------------------------------VLAN.VLANMASK.300 01 | 00 07------------------------------------------------------------------------
