DT Etherlink IV User Manual- 74 - ALL means a local loop forced by line 141 is allowed. Data from line 103 is looped to line 104and clock from line113 is looped to line 115 (use in TTC clocking mode) DATA means local loop forced by line 141 is allowed. Data from line 103 is looped to line 104.4.6.5.37 CommandThis command defines the Nx64 clocking modes.SRC: NORMAL means clocked by DSL INT means clocked by internal oscillator TTC means clocked (Received Clock) by line 113 (Terminal Transmit Clock)DIR: CO means Codirectional mode CONTRA means Contradirectional modeCO_01_CM>EXTCLOCK INT CO4.6.5.38 CommandThe command allows to enter into the submenu for NET settings.4.6.5.39 CommandType and the monitor lists all available commands in the NET sub-menu. If you type H[command] you will get additional help on [command].CP_NET>H-------------------------------------------------------------------------------Type 'H [command]' to get additional help on [command]APPLY [ALL/GROUP] Apply changes to running configurationLINK [NN] Establish local connectionLINKCLEAR Exit all local connectionsNETCONFIG Show network configurationNETCONFIG [N/R/S/B] Show new/running/startup/backup network configurationRSTP DEFAULT Show RSTP state/configurationRSTP [CONF/STATE] Show RSTP state/configurationRSTP [BR/IF] [OPT] [N] Set RSTP Bridge/Interface propertiesRSTP [A..E] [ON/OFF] Switch RSTP ON/OFF at PBVLAN A..EPBVLAN [IF] [A..E] Set port-based VLAN for the interfaceMODE [IF] [ACC/TRUNK/MIX]Set mode of LANx interfaces: access, trunk, mixedVLAN [IF] [1..8] Set default VLAN index for access portsQOS [IF] [0..7] Set default QoS for access portsALLOW [IF] [VLAN list] Set list of VLANS to allow on trunk interfaceVID [1-8] ID Assign VID to the VLAN specifiedSETIP x.x.x.x Set modem IP addressGATEWAY x.x.x.x Set gateway IP addressNETMASK x.x.x.x Set netmaskETHSD [MODE] [N=1-5] Set Nth Ethernet port speedTRAPIP [ADD/DEL] x.x.x.x Set/delete IP address for SNMP trap messagesCOMMUNITY Set SNMP community nameSNMPSET [ON/OFF] Enable/disable SNMP SET commands.NETDEFAULT Set default network configurationCONNECT [N:[1-13/R]] Establish connection to remote unitM Return to Configuration Management MenuH Show available commands-------------------------------------------------------------------------------CP_NET>4.6.5.40 CommandWithout parameters the command displays the running configuration of the networksubsystem and interfaces:CO_NET>NETCONFIG--------------------------------------------------------------------------------Running Network Configuration
