3.2 < Getting Started>3 After a moment a message asking you to print a pattern paper willappear.Press Print. Pattern printing will start.4 When pattern paper is printed out, place the pattern paper on thescanner glass and press Scan.Make sure to align the arrow on the pattern paper with the arrow onthe coner of the scanner glass.5 When setting a color standard completed message appears, pressClose.Setting up the networkYou need to set up the network protocols on the machine to use it as yournetwork printer. You can set up the basic network settings with themachine's touch screen.Note• If a message asking you to select a country appears, select acountry first, then the setting a color standard message willappear.• If you press Cancel, this message will appear again the nexttime you turn the machine’s power on.• The machine should be in a ready mode to set the colorstandard. If the machine is in use, a pop up informing you a job isin a pending state will appear. Press Retry to retry or pressCancel to try it later.NoteThere should be a white paper in the tray to print a pattern paper.NoteYou can also use Setting Color Standard menu to set the colorstandard anytime you want.1 Press Machine Setup on the control panel.2 Press Admin Setting > Setup > Color > Auto Color ToneAdjustment > Setting Color Standard( You can only selectthis option if Auto Color Tone Adjustment is set to On).NoteIf you want to use the USB cable, connect the cable between acomputer and you machine. Refer to the software installation inSoftware section.Supported operating systemsThe following table shows the network environments supported by themachine:NoteIf you want to set up DHCP network protocol, go to http://developer.apple.com/networking/bonjour/download/, select theBonjour program that is appropriate for your computer operatingsystem and install the program. This program will allow you to setnetwork parameters automatically. Follow the instructions in theinstallation window. This program does not support Linux.Configuring network protocol via the machineYou can setup TCP/IP Network parameters please follow the steps listedbelow.1 Make sure your machine is connected to the network with an RJ-45Ethernet cable.2 Make sure you turned on the machine.3 Press Machine Setup on the control panel.4 Press Admin Setting.5 When the login message appears, enter password. Touch thepassword input area, then the question marks appears. Use thenumber keypad on the control panel to enter the password. Oncethe password is entered, press OK. (Factory setting:1111)6 Press the Setup tab > Network Setup.7 Select TCP/IP Protocol.8 Press IP Setting.Item RequirementsNetwork interface Ethernet 10/100/1000 Base-TXNetworkoperating system• Novell NetWare 5.x, 6.x (TCP/IP Only)• Windows 2000/XP/2003/2008/Vista/7/2008 R2• Various Linux OS• Mac OS X 10.3 ~ 10.6Networkprotocols• TCP/IP on windows• DHCP• BOOTP
