Scanning_ 555. Press On to enable job build function.• Off: Disables Job Build feature.• On: Enables Job Build feature.• Display Between Segments: After executing a segment, the job ispaused with this screen is displayed. Then the user can select tokeep sending email or stop.• Delete: Deletes a segment.• Delete All: Deletes all segments.• Send All: Prints all segments.• Add Segment: Adds a new segment.• Cancel: Remove all segments in the list, and cancel the job.6. Press Add Segment.7. Place the originals face up in the DADF or you can use the scannerglass for one sheet of paper.8. Press Start to start the scanning job.9. Repeat step 6 to step 8.10. After adding segments, press Send All.CHANGING THE SCAN FEATURE SETTINGSThis part explains how to adjust the document settings for each scan job,such as resolution, duplex, original size, type, color mode, darkness, andmore. The options you change will be maintained for a certain time, but afterthat period, the options will be reset to default values.DuplexThis feature especially applies when the original documents to be scannedare two-sided. You can select whether the machine scans only one side ofthe paper or both sides of the paper.Press Scan > Scan to Email (Or Scan to Server) > the Basic tab >Duplex. Use left/right arrows to toggle the values.• 1 Sided: For originals that are printed on one side only.• 2 Sided: For originals that are printed on both sides.• 2 Sided, Rotate Side 2: For originals that are printed on both sides.But the back is rotated 180 degrees.ResolutionYou can adjust document resolution.Press Scan > Scan to Email (Or Scan to Server) > the Basic tab >Resolution. Use left/right arrows to toggle the values. The higher value youselect the clear result you get. But the scanning time may take longer.100, 200, 300 dpi resolution is available only when Color Mode is set toColor or Gray. The following table shows detailed information feature,resolution and file format options.Original SizeYou can specify the scanning area on the originals by selecting the pre-defined size, or putting in the margin value or Auto. If you set this option toAuto, the machine senses and determines the size of the original.Press Scan > Scan to Email (Or Scan to Server) > the Advanced tab >Original Size. Use up/down arrows to go to the next screen. Select theappropriate option and press OK.As long as space remains on your device's hard drive, you can addsegments without any restriction.To use 2 Sided and 2 Sided, Rotate Side 2, you have to load theoriginals on the DADF. Because, if the machine can not detect theoriginal on DADF, automatically changes the option to 1 Sided.FEATURE RESOLUTION (DPI) FILE FORMATScan to Email 100, 200, 300, 400,600PDF, Single-Page TIFF,Multi-Page TIFF, JPEGNetScan 100, 200, 300, 400,600PDF, TIFF, JPEGScan to Server 100, 200, 300, 400,600 PDF, Single-Page TIFF,Multi-Page TIFF, JPEG
