Samsung iDCS 100 User Instructions

Also see for IDCS 14B STRIP: User guide User guide User guide User guide

Contents

SAVE NUMBER WITH REDIALTo save the number you just dialed for later use, press the SNR key beforehanging up.To redial this saved number at any time, press the SNR key or dial 17. Thesame line will be selected for you.NOTES:1. If the Hot Keypad feature has been turned off, you must first lift the hand-set or press the SPK or MONITOR key if you are using 7B phone beforeyou begin dialing.2. The saved telephone number is stored in memory until you save anoth-er number.3. Redial does not apply to intercom calls.CHAIN DIALINGYou may manually dial additional digits following a speed dial number orchain as many speed dial numbers together as required:• After the first speed number is dialed, press SPD again and dial anoth-er speed number OR manually dial additional digits following a speeddial number.AUTOMATIC REDIAL/RETRYWhen you are making an outside call and you receive a busy signal, the sys-tem can automatically redial the number for you. It will automatically redialat a pre-programmed interval for up to 15 attempts.• When you hear a busy signal, press the RETRY button.• The system will reserve the line and automatically redial the same num-ber for you. You will hear the call being made through the keyset speak-er. The microphone is muted.• When the called party answers, lift the handset or press the flashingSPK to begin speaking.NOTES:1. If you make another call, auto-redial is canceled.2. To cancel a retry, lift and replace the handset.PULSE TO TONE CHANGEOVERWhen making an outside call on a dial pulse line, press #. All digits dialedafter the # with be sent as tones.27For the purposes of programming speed dial numbers, the programmablekeys are known as A, B, C, D, E and F and are defined below.• The A key is not used.• The B key inserts a flash.• The C key inserts a pause.• The D key is used for pulse to tone conversion. If your system usesrotary (or pulse) dialing C.O. lines, pressing D while entering a speeddial number causes all subsequent digits to be sent as DTMF tones.• The E key is used to hide digits. Display keyset users may want to hidesome speed dial numbers so that they will not show in the display. Whenyou are entering a telephone number, press E. All subsequent digits willbe hidden. Press E again to begin displaying digits.• The F key is used to enter a name. See Personal Speed Dial Namesunder Display Features.• Use the HOLD key to clear a speed dial number.ONE TOUCH SPEED DIALINGYou may assign any speed dial number to an already existing One TouchSpeed Dial button for quick and easy dialing of frequently used numbers.• While on-hook, press TRSF and then dial 107.• Press a One Touch Speed Dial button.• Dial the speed dial number (00–49 or 500–999) that you want assignedto this button.• Press TRSF to store your selection.To call this telephone number, just press the One Touch Speed Dial button.NOTE: If the Hot Keypad feature has been turned off, you must first lift thehandset or press the SPK or MONITOR key if you are using a 7B phonebefore you begin dialing.LAST NUMBER REDIALTo redial the last telephone number you dialed, press the LNR key or dial 19.NOTES:1. If the Hot Keypad feature has been turned off, you must first lift the hand-set or press the SPK or MONITOR key before you begin dialing.2. Redial does not apply to intercom calls.26