Sanyo DS27930, DS32424 Owner's Manual

Also see for DS27930, DS32424: Owner's manual Owner's manual

Contents

Basic Set-up and ConnectionsCATV FRANCHISE NOTE:Cable companies, like publicutilities, are franchised bylocal government authorities.To receive cable programs,even with equipment whichis capable of receiving cablechannels, the consumermust subscribe to the cablecompany’s service.IN FROMSAT.CATV INOUT TO TV S-VIDEOCH3CH4 L- -RAUDIOVIDEOL- -RAUDIOVIDEOS-VIDEOVIDEO AUDIO INPUTYP bP rAV2 AV1COMPONENTR R R RL L L L(MONO) (MONO)UHF/VHF/CATV75ΩAUDIOOUTPUTVIDEOAUDIOAUDIOFROM ANT.OUT TO TVINOUTConnecting Cable Service, RF Antenna, or Satellite Dish Receiver toTV Cable Service RF AntennaSatellite ReceiverTV BackAudio/Video Input Jacks (AV1 / AV2)Connect video equipment here (see pages 5 ~ 6).Note: S-Video connections override the AV1 andAV2 video connections.S-Video Input TerminalTo enhance video detail use the S-Video AV1 andAV2 jacks instead of the Video jacks, if availableon your external equipment.(S-Video connections will override con-nections to the AV input jacks.) (See page 5.)Audio Output JacksConnect external audio equipment here.(See page 6.)Initial Set-up1. Install batteries in remote control, see page 7.2. Connect signal, see below.3. Plug in AC power cord.4. Press POWER key to turn on TV.5. Follow on-screen instructions.480i Component Video In Jacks(Component 3, Y, Pb, Pr)Connect video equipment here.(See page 6.)VCR BackNote: If you do not have a VCRconnect signal directlyto TV 75 ohm jack.QuickTips■ The TV will auto-matically select thecorrect Antennamode for the typeof RF signal youconnect.■ TV will switch offautomatically after15 minutes if there isno signal reception(cable out or stationnot broadcasting).Exception—Whenthe Video mode isselected, the TV willnot automaticallyswitch off whensignal receptionhas stopped for 15minutes.■ If you move the TVto a new location,press the RESET keytwice after connect-ing the signal andturning on the TV.Need help?Visit our Web site atwww.sanyoctv.comor Call 1-800-877-5032 Operational Tip for No Signal Connection:If the TV is used as a monitor only, with a DVD player or some other type of external equip-ment, and no cable or antenna signal is available, the following setup is necessary:Your TV is designed to automatically search for available channels. Therefore, the initialstart up requires that you press the MENU key, enabling the TV to automatically go throughthe channel search process before you can operate the TV. After the initial channel search iscompleted, you must press the MENU key again to complete the channel search process (maytake several minutes).After the channel search process is complete (2 searches), you can press the INPUT key onthe remote control to use the TV as a monitor.4 Basic Set-up & Connections