188 EnglishRECORD SET3INTRODUCTION SETTINGS NETWORKCONTROLNETWORKSETTINGSOTHEROPERATIONz 120 FPS cannot be selected when mirroring is set(JP.119).z When only one camera is connected, recording isperformed at 30 FPS even if 60 or 120 FPS are set.z When two or more cameras are connected and 60 or 120FPS is set, the actual recording rate is roughly therecording rate divided by the number of cameras.(Example: When 8 cameras are connected and therecording rate setting is 120 FPS, the actual recording rateis 15 FPS)12 Set “DURATION” to the desired pre-alarm recording duration.[Settings] ( indicates default setting)Use the following procedure to set the alarm triggers (i.e.,launch signals), which function as operation conditions foralarm recording.13 Set “ALARM TRIGGER” to the desiredlaunch signal for alarm recording.[Settings] ( indicates default setting)z External alarm detection:This is used to describe input of an external detectionsignal from a door switch or the like to the unit’s ALARM INterminal.z Motion sensor detection:This refers to detection of motion on the monitor inaccordance with motion sensor settings.z The motion sensor settings are made on the digital videorecorder.14 Click [SAVE].The setting is saved.Setting Description5SEC, 10SEC, 20SEC,40SEC, 1MIN, 2MIN,3MIN, 4MIN, 5MIN, 10MIN,15MINRecords for the set duration.Setting alarm triggersSetting DescriptionALARM Starts recording when an external alarm isactivated.SENSOR Starts recording when a motion sensor isactivated.ALARM ANDSENSORStarts recording when both an external alarmand a motion sensor are activatedsimultaneously.ALARM ORSENSORStarts recording when an external alarm or amotion sensor is activated independent of theother.
