Sanyo PJLINK PLC-WM4500 Owner's Manual

Also see for PLC-WM4500: User manual Owner's manual Owner's manual Manual Manual

Contents

16The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the remote controlcodes prevents interference from other remote controls when several projectors or video equipment next to each other areoperated at the same time. Change the remote control code for the projector first before changing that for the remote control.See “Remote control” in the Setting Menu on page 58.Press and hold the MENU and a number button (1–8) formore than five seconds to switch between the codes.1To initialize the remote control code, slide the RESET/ ON/ALL-OFF switch to “RESET”, and then to “ON”. The initialcode is set to Code 1.MENU buttonNumber buttons(1-)RESET/ON/ALLOFF SwitchPress and hold the MENU and a number button(1-8) that corresponds to the remote control codefor more than five seconds to switch between thecodes.Part Names and FunctionsRemote Control CodeAdjustable FeetProjection angle can be adjusted up to 4.0 degrees with theadjustable feet.Rotate the adjustable feet and tilt the projector to the proper height;to raise the projector, rotate the both feet clockwise.To lower the projector or to retract the adjustable feet, rotate theboth feet counterclockwise.To correct keystone distortion, press the KEYSTONE button on theremote control or select Keystone from the menu (see pages 14,31, 44, 50).Adjustable Feet