Sanyo PJLINK PLC-WM4500 Owner's Manual

Also see for PLC-WM4500: User manual Owner's manual Owner's manual Manual Manual

Contents

59PNote:Factory default is Ready: 5 Min.SettingSelect a location of the infrared remote receiver of the remote control.See “Remote Control Receivers and Operating Range” on page 15 fordetails.All ............ Activate all of the receivers.Front & Top . . . . . .Activate both the front and top receivers.Top & Back . . . . . . Activate both the top and back receivers.Front & Back . . . .Activate both the front and back receivers.Front ....... Activate only the front receiver.Top .......... Activate only the top receiverBack ........ Activate only the back receiver.Timer left before Lamp is off.Power managementFor reducing power consumption as well as maintaining the lamp life,the Power management function turns off the projection lamp whenthe projector is not operated for a certain period.Select one of the following options:Ready .................. When the lamp has been fully cooled down, thePOWER indicator changes to green blinking. Inthis condition, the projection lamp will be turnedon if the input signal is reconnected or anybutton on the side control or remote control ispressed.Shut down ........... When the lamp has been fully cooled down, thepower will be turned off.Off ........................ Power management function is off.Timer.................... If the input signal is interrupted and no buttonis pressed for more than 30 seconds, the timerdisplay with No signal appears. It starts thecountdown until the lamp is turned off. Use thePoint pq buttons to set the Timer(1~30Min).This function is available when operating the projector via network.Network .......... Supply the power to the network functioneven after turning off the projector. You can turnon/off the projector via network, modify networkenvironment, and receive an e-mail about projectorstatus while the projector is powered off.Eco.................... Select Eco when you do not use the projectorvia network. The projector’s network function willstop when turning off the projector.Refer to the owner’s manual of “Network Set-up and Operation”.PNote:• Factory default is Network.• When selecting Network, the cooling fans may be running dependingon the temperature inside the projector even if the projector is turned off.• When Eco is selected and the projector is in Stand-by, thecommunication of RS-232C serial port is not available.RC sensorPower managementStandby mode