Sanyo PJLINK PLC-WM4500 Owner's Manual

Also see for PLC-WM4500: User manual Owner's manual Owner's manual Manual Manual

Contents

54SettingEnter a Logo PIN codeUse the Point pq buttons to enter a number. Press the Point ubutton to fix the number and move the red frame pointer to the nextbox. The number changes to ⁄. If you fixed an incorrect number,use the Point u button to move the pointer to the number you wantto correct, and then enter the correct number.Repeat this step to complete entering a four-digit number.After entering the four-digit number, move the pointer to Set. Pressthe SELECT button so that you can start to operate the projector.If you entered an incorrect Logo PIN code, Logo PIN code andthe number (⁄⁄⁄⁄) will turn red for a moment. Enter the correctLogo PIN code all over again.Logo PIN code can be changed to your desired four-digit number.Press the Point q button to select Logo PIN code change andthen press the SELECT button. The Current logo PIN code dialogbox appears. Use the Point pq buttons to set the current logoPIN code. The New logo PIN code dialog box appears. Set a newLogo PIN code, the confirmation box appears, and choose Yes toset the new Logo PIN code.Be sure to note the new Logo PIN code and keep it on hand. If youlost the number, you could no longer change the Logo PIN codesetting.Use the Point pq buttons to switch On or Off, and then press theSELECT button to close the dialog box.Change the Logo PIN code lock settingEnter a Logo PIN codeAfter a correct Logo PIN codeis entered, the following dialogbox appears.CAUTION:WHEN yOU HAVE CHANGED THE LOGO PIN CODE, WRITEDOWN THE NEW PIN CODE IN COLUMN OF THE LOGO PINCODE NO MEMO ON PAGE 6, AND KEEP IT SECURELySHOULD THE LOGO PIN CODE BE LOST OR FORGOTTEN, THELOGO PIN CODE SETTING CAN NO LONGER BE CHANGEDChange the Logo PIN code lock settingLogo PIN code changeChange the Logo PIN code