Sanyo PJLINK PLC-WM4500 Owner's Manual

Also see for PLC-WM4500: User manual Owner's manual Owner's manual Manual Manual

Contents

7Before calling your dealer or service center for assistance, check the items below once again.1. Make sure you have properly connected the projector to peripheral equipment as described on pages 19-21.2. Check the cable connection. Make sure that all computers, video equipment, and power cords are properly connected.3. Make sure that all power is switched on.4. If the projector still does not produce an image, restart your computer.5. If an image still does not appear, disconnect the projector from your computer and check your computer monitor’s display.A problem may be noticed with your graphics controller rather than with the projector. (When you reconnect the projector,be sure to turn the computer and monitor off before you turn on the projector. Turn on equipment in the order of theprojector and computer.)6. If a problem still persists, check the following solutions.AppendixProblem: SolutionsNo power– Plug the power cord of the projector into the AC outlet.– Wait until the POWER indicator stops blinking to turn on the projector again. (Seepage 23)– Check the WARNING TEMP. indicator. If the WARNING TEMP. indicator is blinking,the projector cannot be turned on. (See page 71.)– Unlock the Key lock function for the projector. (See page 61)– See if the filter cartridge is inserted. (See page 66)– Check the projection lamp. (See page 68)PIN code dialog boxappears at start-up– PIN code lock is being set. Enter a PIN code; the “1234” or numbersPIN code lock is being set. Enter a PIN code; the “1234” or numbers you have set(See pages 23, 61-62)The initial display is notshown– Make sure Off or Countdown Off is not chosen at Display function.(See “Setting” section on page 52)The initial display is notsame with the default one– Make sure User or Off is not chosen at Logo select function.(See “Setting” section on page 52)When the projector is onand you press the inputbutton, an icon otherthan the Lamp mode iconappears– That is the Filter warning icon. (See pages 64-65)That is the Filter warning icon. (See pages 64-65)An icon other than Inputmode or Lamp mode iconappears– That is the Lamp replacement icon or the Filter warning icon. (See pages 57, 64-65,That is the Lamp replacement icon or the Filter warning icon. (See pages 57, 64-65,68)No image– Check the connection between your computer or video equipment and the projector.– See if the input signal is correctly output from your computer. Some laptop computersmay need to be changed the setting for monitor output when connected to theprojector. See your computer’s instruction manual for the setting.– It takes about 30 seconds to display an image after turning on the projector.– See if the selected system is corresponding with your computer or video equipment.– Select correct input source once again through menu operation. (See pages 33-35)– Make sure the temperature is not out of Operating Temperature (41˚F–104˚F [5˚C–40˚C]).- When No show is operating, the image cannot be displayed. Press the NO SHOWbutton or any other button on the remote control.appears on the screen– End of lamp life is approaching. Replace the lamp with a new one promptly. (Seepage 68)Troubleshooting