11Part Names and FunctionsTerminals and Connectorsr R/C jACKWhen using the wired remote control, connect thewired remote control to this jack with a remotecontrol cable (not supplied).e USB CONNECTOR (series B)USB connector is to used to service the projector.y S-VIDEO jACKConnects the S-VIDEO output signal from videoequipment to this jack (p.21).q SERIAL PORT IN TERMINALIf you control the projector from a computer, youmust connect a cable (not supplied) from yourcomputer to this RS-232C terminal.w SERIAL PORT OUT TERMINALThis terminal outputs signal from SERIAL PORT IN.More than two projectors can be controlled withone computer by connecting SERIAL PORT IN ofanother projector to this RS-232C terminal.u 5 BNC jACKConnects the component or composite videooutput signal from video equipment to VIDEO/Y,Pb/Cb, and Pr/Cr jacks or connect the computeroutput signal (5 BNC Type [Green, Blue, Red,Horiz. Sync, and Vert. Sync.]) to G, B, R, H/HV, andV jacks (pp.20–21).q wyu!0 DIGITAL (DVI-D) TERMINALConnects computer output (Digital/DVI-D type) tothis terminal (p.20).HD (HDCP Compatible) signal can be alsoconnected (p.21).i ANALOG TERMINALConnects the computer (or RGB scart) outputsignal to this terminal (pp.20–21).tret LAN PORTConnecting the Ethernet cable See the owner’smanual of “Network Set-up and Operation” fordetails.o HDMI TERMINALConnects the HDMI output signal from videoequipment to this terminal. (pp.20–21)o i!0