Sanyo PLC HF10000L Owner's Manual

Contents

4Select the desired screen size that conforms to the input signalsource.Screen menuProvides the image within a screen size keeping its originalaspect ratio.✔Note• The projector cannot display any resolution higher than2048 x 1080. If your computer’s screen resolution ishigher than 2048 x 1080, lower the resolution beforeconnecting the projector.• The image data other than 2048 x 1080 is modified to fitthe screen size in initial mode.• Full, Wide(16:9), Zoom, True and Digital zoom +/– cannotbe selected when no signal is detected in the PCSystem Menu. (p.35)• You cannot zoom out an image smaller than normal sizefor display in Custom mode.1Press the MENU button to display the On-ScreenMenu. Use the Point ed buttons to select Screen andthen press the Point 8 or the SELECT button.Use the Point ed buttons select the desired item andthen press the SELECT button.Screen Size AdjustmentDisplays an image based on the output resolution from thecomputer- Less than the panel resolution (2048x1080)The image is centered on the screen.- Equal to the panel resolution (2048x1080)"Normal" appears at a corner of the screen.- Higher than the panel resolution (2048x1080)Panning mode begins with "True" displayed on the screen.In this case, the Zoom function is not available.When the original image size is larger than the panel size(2048x1080), the projector enters to the panning modeautomatically. Use the Point ed7 8 buttons to pan the image.When adjusted, the arrows will turn red. When reached to thecorrection limits, the arrows will disappear.Scales the image proportionally to fit the entire screen.Either side of image may go over the screen.Provides the image to fit full screen size.Provides the last stored aspect screen image.Provides the image at the 16:9 wide screen ratio.Computer InputNormalFullWide (16:9)ZoomTrueCustom