40Image Adjust MenuPress the MENU button to display the On-ScreenMenu. Use the Point ed buttons to select Imageadjust and then press the Point 8 or the SELECTbutton.1 Use the Point ed buttons to select the desired itemand then press the SELECT button to display theadjustment dialog box. Use the Point 7 8 buttons toadjust the setting value.Press the Point 7 button to decrease the contrast; press thePoint 8 button to increase the contrast (from 0 to 63).Press the Point 7 button to decrease the brightness; pressthe Point 8 button to increase the brightness (from 0 to 63).Use the Point 7 8 buttonsto adjust the setting value.Selected Image modeImage AdjustmentComputer InputThe Color Management function can be used to adjust the LEVEL,PHASE, and GAMMA of the selected display colors (except forblack, white, and gray) on the screen and replace these colors withother colors if required.You can store up to eight (8) color management data.1 Select and highlight Color Management by using the Pointed buttons and press the SELECT button. The projectedimage freezes, and the COLOR MANAGEMENT POINTERappears.Use the Point ed7 8 buttons to move the pointer to thespot where you want to adjust the color and then press theSELECT button. The COLOR SELECTION window appears,and the color in the center of the pointer is selected and youcan adjust the color.2Use the Point ed7 8 buttons to adjust the LEVEL andPHASE of the color, and then press the SELECT button toconfirm the setting. Then use the Point ed buttons to adjustthe GAMMA for the color and press the SELECT button toaccept the setting. After adjusting, press the SELECT buttonto go to the COLOR MANAGEMENT LIST.3COLOR SELECTION MODEGo to the COLOR MANAGEMENT LIST.LISTReturn to the COLOR MANAGEMENT POINTER. (If you pressthe MENU button on the side control or the remote control ,it returns to the COLOR MANAGEMENT POINTER and youwill need to reselect and readjust the color.)COLOR M.COLOR MANAGEMENTPOINTERPOINTER MODE✔NoteWhen White balance Red, Green or Blue is adjusted,Color temp. will change to Adj.ContrastBrightnessColor managementSelect and highlight Color Management by using the Pointbuttons and press the SELECT button.