Sanyo PLC-WU3800 Manual

Also see for PLC-WU3800: Dimensional drawing Manual Command list Specification sheet Owner's manual

Contents

PLC-WU3800 Expand Serial Command Functional Specifications13/746. Status Read Command Table6.1 Image Status Read Command TableStatus read command ItemCR_BRIGHT[CR] Get Brightness valueCR_CONT[CR] Get Contrast valueCR_COLOR[CR] Get Color valueCR_TINT[CR] Get Tint valueCR_SHARP[CR] Get Sharpness valueCR_GAMMA[CR] Get Gamma valueCR_WBAL-R[CR] White Balance Red valueCR_WBAL-G[CR] White Balance Green valueCR_WBAL-B[CR] White Balance Blue valueCR_COLTEMP[CR] Get setting value of Color temperatureCR_NZRED[CR] Get setting status of Noise reductionCR_PROGV[CR] Get setting status of Progressive scanCR_IMAGE[CR] Get Selected Image statusCR_IMGGMD[CR] Get setting value of Image Gamma6.2 PC Adjust Status Read Command TableStatus read command ItemCR_FSYNC[CR] Get setting value of Fine SyncCR_TDOTS[CR] Get setting value of Total DotsCR_CLAMP[CR] Get setting value of ClampCR_H-POS[CR] Get setting value of Horizontal PositionCR_V-POS[CR] Get setting value of Vertical PositionCR_DDOTS[CR] Get setting value of Display DotsCR_DLINE[CR] Get setting value of Display LineCR_PCSTORE[CR] Get Free or Stored status for PC Adj. mode1-56.3 Video Status Read Command TableStatus read command ItemCR_SERSYS[CR] Get selected current signal. When in Auto mode, it returns aresult by Auto detect.6.4 Input Status Read Command TableStatus read command ItemCR_INPUT[CR] Get selected Input No.CR_SOURCE[CR] Get selected source of currently selected InputCR_SRCINP1[CR] Get selected source of Computer 1CR_SRCINP2[CR] Get selected source of Computer 2CR_SRCINP3[CR] Get selected source of HDMICR_SRCINP4[CR] Get selected source of VideoCR_SRCINP5[CR] Get selected source of S-videoCR_SYSTEM[CR] Get selected system status in Input modeCR_SYSLIST[CR] Get selectable System tableCR_MODELIST[CR] Get selectable Mode table