Sanyo PLC-WU3800 Manual
Also see for PLC-WU3800: Dimensional drawingManualCommand listSpecification sheetOwner's manual
                                                                          | |
Contents
|
PLC-WU3800 Expand Serial Command Functional Specifications23/748.5.4 CF_H – POS CommandCommand “CF_H-POS_%1”[CR]%1“0000~nnnn” --- Directly select Horizontal Position setting value“nnnn” shows maximum value, it is current Total Dots value - Display Dots value“UP” -------------- Current Horizontal Position setting value + 1“DN” -------------- Current Horizontal Position setting value - 1DetailsSet Horizontal Position value of PC signal.The value set by this command will not be saved to projector. Therefore, whenturning into Standby mode or ALL is OFF, the value returns to original setting.This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “101”[CR] ---- when Input for Video is selected8.5.5 CF_V – POS CommandCommand “CF_V-POS_%1”[CR]%1“0000~nnnn” --- Directly select Vertical Position setting value“nnnn” shows maximum value, it is current Total Line value - Display Line value“UP” -------------- Current Vertical Position setting value + 1“DN” -------------- Current Vertical Position setting value – 1DetailsSet Vertical Position value of PC signalThe value set by this command will not be saved to projector. Therefore, whenturning into Standby mode or ALL is OFF, the value returns to original setting.This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “101”[CR] ---- When Input source is Video system8.5.6 CF_DDOTS CommandCommand “CF_DDOTS_%1”[CR]%1“0256”~”nnnn” --- Directly select Display Dots setting value“nnnn” shows maximum value, it is current Total Dots value - HorizontalPosition valueEven number is available and when odd number is set, it is rounded out.“UP” -------------- Current Display Dots setting value + 2“DN” -------------- Current Display Dots setting value – 2DetailsSet Display Dots value of PC signalThe value set by this command will not be saved to projector. Therefore, whenturning into Standby mode or ALL is OFF, the value returns to original setting.This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “101”[CR] ---- When Input for Video is selected |
Related manuals for Sanyo PLC-WU3800
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine