Sanyo PLC-WU3800 Manual

Also see for PLC-WU3800: Dimensional drawing Manual Command list Specification sheet Owner's manual

Contents

PLC-WU3800 Expand Serial Command Functional Specifications37/748.10.4 CF_AUTOSETUPKEYSTONE CommandCommand “CF_AUTOSETUPKEYSTONE_%1”[CR]%1“AUTO” ------------------- Set Auto Keystone function to Auto“MANUAL” --------------- Set Auto Keystone function to Manual“OFF” --------------------- Set Auto Keystone function to OFFDetailsSet Keystone function of Auto setupThis command is available in normal Power ON status.Note) It is unable to set Keystone, PC ADJ. and Input search to OFF at once.e.g. If projector receives Keystone OFF command while Auto PC ADJ. and Inputsearch are OFF, it returns error code “101”..Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.5 CF_INPUTSEARCH CommandCommand “CF_INPUTSEARCH_%1”[CR]%1“OFF” ------------------------- Set Input search operation to OFF“ON1” ------------------------- Set Input search operation to On1“ON2” ------------------------- Set Input search operation to On2DetailsSet Input search operation mode.The status set by this command is stored in EEPROM and its setting is effectiveafter ALL is OFFThis command is available in normal Power ON status.Note) It is unable to set Keystone, PC ADJ. and Input search to OFF at once.e.g. If projector receives Input search OFF command while Auto PC ADJ. andKeystone are OFF, it returns error code “101”.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.6 CF_AUTOSETUPCommand “CF_AUTOSETUP_%1”[CR]%1 “START” ------------------- Execute Auto SetupDetailsExecute Auto SetupNote) CF commands does not execute while Auto setup is in process. If thecommand is sent during this, projector returns error code “302”Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.7 CF_BACKGND CommandCommand “CF_BACKGND_%1” [CR]%1“BLUE” -------------------- Select Blue Back“USER” ------------------- Select User“BLACK” ------------------ Select Black Back“UP” ---------- Switch forward (Blue Back→User→Black Back→Blue Back)“DN” --------- Switch backward (Blue Back→Black Back→User→Blue Back)DetailsSet Screen status for no signal.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and the setting remainseven after the power is turned to ALL OFF status.*When 1=”USER” is received, error code “101” is returned, in the case ofCapture non-practice.Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]