PLC-XC50/55 Expand Serial Command Functional Specifications18/678.4.8 CF_COLTEMP CommandCommand “CF_COLTEMP_%1”[CR]%1“000” ------ Xlow“001” ------ Low“002” ------ Mid“003” ------ HighDetailsSet Color Temperature. (Available only in the normal Power ON status)The value set by this command will not be saved to the projector. Therefore, whenturning into Standby-mode or ALL is OFF, the value returns to original setting. (Thevalue is held in Suspend mode.)This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.4.9 CF_PROGV CommandCommand “CF_PROGV_%1”[CR]%1“FILM” -------- Select Progressive Mode FILM“L1” ----------- Select Progressive Mode L1“L2” ----------- Select Progressive Mode L2“OFF” --------- Cancel Progressive scan“UP” -----------Switch Progressive mode in forward directionOFF -- L1 -- L2 -- FILM -- OFF“DN” -----------Switch Progressive mode in backward directionOFF -- FILM -- L2 -- L1 -- OFFDetailsSet / cancel Progressive scanThe value set by this command will not be saved to projector. Therefore, whenturning into Standby-mode or ALL is OFF, the value returns to original setting. (Thevalue is held in Suspend mode.)This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.4.10 CF_NZRED CommandCommand “CF_NZRED_%1”[CR]%1“OFF” ------- Cancel Noise Reduction“L1” --------- Noise Reduction for moving image“L2” --------- Noise Reduction for still image“UP” -----------Switch Progressive mode in forward directionOFF -- L1 -- L2 -- OFF“DN” -----------Switch Progressive mode in backward directionOFF -- L2 -- L1 -- OFFDetailsSet / cancel Noise Reduction. The value set by this command will not be saved toprojector. Therefore, when turning into Standby-mode or ALL is OFF, the valuereturns to original setting. (The value is held in Suspend mode.)This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]