PLC-XC50/55 Expand Serial Command Functional Specifications51/67Input isVideo,S-Video“AUTO” --------------- Auto is selected“NTSC” --------------- NTSC is selected“NTSC443” ---------- NTSC4.43 is selected“PAL” ------------------ PAL is selected“SECAM” ------------- SECAM is selected“PAL M” ------------- PAL-M is selected“PAL N” ------------- AL-N is selectedProjector returns selected System status regardless of thesignal input.Unacceptable ““Error Code”[CR]9.7.7 CR_SYSLIST CommandCommand “CR_SYSLIST”[CR]Details Get selectable System titlesResponseAcceptable “000_%1_%2_..._%x” [CR]%1- When Input is PC-Analog“XGA1” ------------ XGA1is selectable“1080I ” ----------- 1080i is selectableProjector does not return Auto,Mode1-5When there is no signal, it returns Error Code “101”-When Input is PC-Digital AV-HDCP“D-XGA” ----------- D -XGA is selectable“D-720P” ---------- D -720P is selectableWhen there is no signal, it returns Error Code “101”-When Input is Y,Pb/Cb,Pr/CrReturns all the System titles on Menu including Auto“AUTO” ------------ Auto is selectable“1080I” ------------ 1080i is selectable“1035I” ------------ 1035i is selectable“575I” ------------ 575i is selectable“480I” ------------ 480i is selectableProjector does not return Error Code “101” even if there is nosignal.-When Input is Video, S-VideoReturns all the System titles on Menu including Auto“AUTO” ---------Auto is selectable“PAL” ------------ PAL is selectable“SECAM” ------ SECAM is selectable“PAL-N” --------- SECAM is selectableProjector does not return Error Code “101” even if there is nosignal.Unacceptable ““Error Code”[CR]