Sanyo PLC-XC50 - 2600 Lumens Manual

Also see for PLC-XC50 - 2600 Lumens: Owner's manual Manual Specification sheet Owner's manual

Contents

PLC-XC50/55 Expand Serial Command Functional Specifications66/679.12.7 CR_TEMP CommandCommand "CR_TEMP”[CR]DetailsGet current temperature inside a projector.If there are several sensors installed, it is possible to get information from all thesensors at once.ResponseAcceptable “000_%1_%2_%3”[CR]%1,%2,%3%1= Sensor 1 temperature (External temperature)%2= Sensor 2 temperature (Inside temperature1)%3= Sensor 3 temperature (Inside temperature2)%1,%2 are consists of 6 bites fixedThere must be 1 space between %1 and %2, and, %2 and %3e.g. _31.5F“_” means a space and “_” changes into “-“, when temperaturegets below freezing.e.g. -05.5FThe last character shows if corresponding sensor is underabnormal temperature.“F” ------- Abnormal temperature“W”-------Close to abnormal temperature(Temperature is as highto display Warning)“S” -------Not close to abnormal temperature (Temperature is lowenough and safe.)“N”-------Applicable sensor does not detect abnormal temperature“E” -------Not able to return temperature dataWhen several sensors are incorporated, projector returns valuescontinuously.e.g. “_31.5F__35.2S__38.0W”[CR]A data of sensor 1 comes first and a data of sensor 2 follows after1 space.As described respectively in e.g., sensor 1 detects abnormaltemp., sensor 2 detects 35.2 degrees which means safety, andsensor 3 is 38 degrees which is close to abnormal temp.In case projector cannot return its data due to some hard warefailure, the last character becomes “E” such as “_00.0E”.Some of the projectors get abnormal temperature because ofheat of Lamp ballast in Standby mode or Powering ON.Therefore detection of abnormal temperature is suspended whileStandby mode or adequate time after Power ON, and during thattime projector returns “_----N” as a temperature data.Unacceptable “Error Code”[CR]

/ 67

Related manuals for Sanyo PLC-XC50 - 2600 Lumens