22Chapter 2 Setup proceduresInstallation of Driver for USB displayIt is required to install the software into your computer to use the USB display function . Please installthe software as follows.1. Select “Display” in the “USB terminal” from the setting menu of the projector.2. Select “USB Display” with the Point 54 buttons and press SELECT button. Then the Menu willdisappear, the “Please wait...” message will appear, and switching operation will start. Switching willtake a while and after completing the operation, the “Ready for use” message will appear.3. Connect the computer to the projector with a USB cable.4. New Hardware is detected and then "Found NewHardware Wizard" window will be displayed. Select "No,not this time" and click Next button.5. Set the supplied Network Viewer & Capture 5 CD-ROM into the CD-ROM drive of your computer.(If your computer does not provide the CD-ROM drive, insert the supplied USB memory into yourcomputer.) Select "Install from a list or specific location" and click Next button.6. Select "Search for the bestdriver in these locations",check 2 boxes, and then clickBrowse button, and select"USB Driver" folder in theCD-ROM or USB memory, andclick OK button to proceedwith installing.7. During the installation, following window may appear,click Continue Anyway button.8. Click Finish to completethe installation. You can find out "USB Driver" folder is in "WIN" folder in the CD-ROM or the root directory of the supplied USBmemory.
