58Chapter 6 Basic setting and operationConfiguring wireless LAN security settingClick page [3] of setting pages. Following wireless LAN securitysetting can be done. After completing the configuration, pressSet button.Item DescriptionNetwork security ...Sets the type of encryption. Following types are available.DisableWPS Push ButtonWPS PIN codeWEP64(40)bit OpenWEP64(40)bit ShareWEP128(104)bit OpenWEP128(104)bit ShareWPA-PSK(TKIP)WPA2-PSK(AES)Input type.................ASCII or HEX. See item "Notes for entering characters"Key index1 - 4..........Enter keys of encryption.The used number of character changes as the table below according to the type of WEPencryption and input type.WEP option CharactersWEP64(40)bit ASCIIWEP64(40)bit HEXWEP128(104)bit ASCIIWEP128(104)bit HEX5 characters10 characters13 characters26 charactersFour key indexes can be set, however, the only one with check on its radio button iseffective. Both of the number and value of the key index in effect must be same as thoseof your computer and the access point.Depending on computers and access points, you may be allowed to select only one WEPkey. In that case, use key index1.PSK..............................Available when the "WPA-PSK(TKIP)" or "WPA2-PSK(AES)" is selected.The PSK key must be no fewer than 8, nor more than 63 digits with ASCII code, and 64digits with Hex code.
