TEC MA-600 Series Programming Manual

Also see for MA-600 Series: Owner's manual Maintenance manual

Contents

6. TERMINAL FILE PROGRAMMING EO3-111066.39 Special Rounding Process Setting, 1-digit type6-1616.39 Special Rounding Process Setting, 1-digit typeFor Special Rounding and Denmark/Australia rounding, the pre-rounded value of the least effective digit and thepost-rounded value are set here. This operation is effective when the option “Special Rounding ACTIVE” and “1digit subject to Special Rounding” are selected (System Option Address No. 33, Bit No. 3 SET & Bit No. 4RESET).Any time outside a saleMode Lock: SET1) Menu Tree2) Operation FlowchartMain Menu ECR is being outside a sale and in SET mode.Depress [↓] five times then [Enter].orDepress [6].“6 OTHER” is selected.Depress [↓] five times then [Enter].orDepress [6].“6 ROUND TBL 1 DIGIT” is selected.Maximum value of the range of the digitsubject to round (1 digit)+Post-rounded value (2 digits)Maximum value of the range of the digit subject to round: 0 to 9Post-rounded value: 00 to 09[Enter][End] This setting is ended. A long receipt is issued and the displayreturns to Main Menu screen.NOTES:1. The values shown in the example below are default setting values after a RAM Clear.2. When the “Post-rounded Value” is to be 10 (i.e. the final break point), the break entry is automatically set(refer to the example below.). Therefore, it does not need to be entered. Entering a value larger 9 for thePost-rounded Value will not cause an error. However, the rounding process will occur only on the leasteffective digit in sales entries.3. A maximum of 10 breaks can be programmed.3) ExampleTo set the following rounding table:Pre-rounded value of theleast effective digit Post-rounded value0 to 2 0 (=00)3 to 7 5 (=05)8 to 9 10**: Repeat for the next break entries (max. 10 breaks).Ignore in settingOPERATIONCONDITION