Electrical Controls25Controls and IndicatorsElectrical ControlsSwitch orIndicator Function ActiveOnlineActiveOfflinePower Switch Turns printer on and off: 1 = on, 0 = off. This switch is also a circuitbreaker.Status Indicator On when the printer is online, off when the printer is offline. Flashes toindicate a fault or warning. 9 9LCD Liquid Crystal Display. Displays printer status messages, fault messages,and menus which permit user to set various configurations. 9 9ONLINE Toggles the printer online and offline. Clears the printer after a fault iscorrected and returns the printer to offline state. Pressing CLEAR silencesthe audible alarm (if enabled).9 9LF Performs a line feed (LF - line feed). A single press of the LF key causes aline advance. 9 9FF Performs a form feed paper advance (FF - form feed) . A single press ofthe FF key causes a form advance to the top of the next form. 9 9CLEAR In a fault state this key attempts to clear the fault. When the fault is clearedthe printer returns to the offline mode.When the printer is in offline mode and no fault is present, this key allowsentry into the Clear menu..9TOF Moves paper downward from TOF (Top Of Form) alignment mark to theprint station and sets this as the first line of print on a page, independent offorms length. If there are data in the buffers, the printer slews to the pageposition where printing left off and prints the data.9VIEW When the printer is online or offline, pressing this key executes the view oreject function. A short press of the View key performs the view function. Ifthe key is held down for more than one second, the key eject function isperformed.If online with data in the printer buffer, the data prints and the key functionsas described below.For cabinet models, pressing the VIEW key moves the last data printed tothe tractor area for viewing. While in the view state, the message "Printerin View" displays, and pressing the UP or DOWN arrow keys moves thepaper up or down in 1/72 inch increments. Pressing VIEW a second timemoves the paper back to the adjusted print position.If in a fault state, this key will be ignored.9 9CONFIG In offline mode, this key allows for fast selection of any of the previouslystored configurations. Pressing this key causes the printer to cycle throughthe following messages: Load Config., Factory Config, Load Config 1,Load Config 2, Load Config 3,...,Load Config 8.9
