Position the Paper Out Sensor409Position the Paper Out SensorFigure 107. The Paper Out SensorThe paper out sensor indicates when the printer runs out of paper. (Thesensor does not work with black backed forms.) Unlike the standard pedestalprinter, the ZTP printer requires you to load the paper through the paper outsensor slot (Figure 104 and Figure 107). Correct positioning of the paper outsensor ensures that the last form the printer prints will be properly presentedto the tear bar. To position the paper out sensor, do the following:1. Position the paper properly at the tear bar (page 411).2. Loosen the paper out sensor by turning the sensor knobcounterclockwise.3. Position the paper out sensor so that there are at least 2 inches betweenthe bottom of the aluminum extrusion bar and the top of the paper outsensor.IMPORTANT For optimal performance, 2 inches is recommended for 11 inch forms.For shorter forms, position the paper out sensor so that there are atleast 2 inches between a perforation and the top of the paper out sensor.4. Tighten the paper out sensor by turning the sensor knobs clockwise.5. Press ONLINE. When the first print job is sent to the printer, the paper isdrawn into the printer, the top of form aligns with the print station, and theprint job begins.183490bSensor KnobPaper Out SensorPaperExtrusion BarAt least 2 inches
