11 – Menu and parameter reference–Menu groups78 TASCAM DA-98HR11.1.9 Menu group 811.1.10 Menu group 9Menu item Parameter(s) Values ReferenceGenerate StartTimeTime value Defaults to 00:00:00:00 9.3.2, “Recording time-code using the genera-tor”Generate Mode Run/StopModeStop, RunReset, ContinueTC Frame Mode System framerate, TC trackrate (view-only)30 DF,30 NDF, 29.97DF, 29.97NDF, 25 F, 24 F9.4, “Selecting the framerate”Fs Shift Mode Pull up/downparametersoff, Pull Down 30NDF,Pull Up 29.97NDF,Pull Up29.97 DF,Pull Down 30DF9.4.1, “Pull up and pulldown (Fs shift)”TC Record Source TimecodesourceExternal TC, GeneratorTC, Tapeaa.If Tape is selected, there will be another parameter automatically appended. This parameter will be Assemble,ABS, ABS/Offset, ABS/Auto13 or ABS/Auto23 depending on the setting made in theTape TC Mode menu 9.2, “Tape timecode mode”.9.3, “Recording time-code”Tape TC Mode Tape timecodesource TcTrack, ABS, ABS-Ofsb,ABS-13, ABS-23b.If the ABS-Ofs (Absolute timing with offset) option is selected, the bottom line of the display changes to allow directentry of the desired offset value.9.2, “Tape timecodemode”Menu item Parameter(s) Values ReferenceCleaning Mode on/offCounteroff, onAutomatically incremented12.1, “Head and trans-port cleaning”Block Error Rate Tape area No parameters — shows error rate at differentpositions12.2, “Checking errorrates”Power-on Message Startup mes-sageDefaults to TASCAM HR 7.15, “Setting the power-on message”Setup SetupmemoriesLoad/Save1, 2 , 3 and F (factory)Load, Save12.4, “User setups inRAM”Error Mute enable mute, no mute 7.14, “Disabling auto-matic muting”G e n S t a r t F s S h i f tG e n M o d e T c R e c S r cT C F r a m e T a p e T CC l e a n i n g S e t u pB E R D i s p E r r o r M u t eP w r O n M s g
