36 TASCAM DP-32SD6 - Basic Recording3. Press the EQUALIZER ON/OFF button to the right of theLOW FREQ knob to turn the equalizer on/off.The equalizer parameters are as follows.GAIN FREQHIGHSetting range: ±12dB(Default: 0 dB)Setting range: 1.7 kHz to18 kHz(Default: 10 kHz)MIDSetting range: ±12dB(Default: 0 dB)Setting range: 32 Hz to18 kHz(Default: 1.0 kHz)LOWSetting range: ±12dB(Default: 0 dB)Setting range: 32 Hz to1.6 kHz(Default: 100 Hz)Use track SELECT buttons to select desired tracks.Use INPUT SOURCE buttons to select desired inputs.Use HIGH, MID and LOW GAIN knobs to adjust the gain ofeach band.Use the HIGH, MID and LOW FREQ knobs to adjust thecenter frequency of each band.Use the MID Q knob to set the resonance (width) of the MIDFREQ band.Setting range: 0.25 to 16 (Default: 0.5)NOTE• The "Q" value is the center frequency of the equalizer divided bythe bandwidth. A high Q value reduces the range of the cut orboost applied to the frequencies. Depending on the equalizersetting, the graph at the top of the screen changes.• If you press the F1 (EQ FLAT) button, all the settings shown onthe open Mixer screen will be restored to their default values.3. After making the settings, press the HOME button to returnto the Home screen.DIGITAL TRIM setting (track only)Depending on the playback sound, EQ boosting could causedistortion (digital clipping). If this happens, use the DIGITAL TRIMto lower the playback level before the EQ.1. Use the CURSOR (5/b/g/t) buttons to move the cursorto the DIGITAL TRIM display area.Digital trim2. Turn the JOG/DATA dial to set the value.Setting range: -42dB to +6dB (Default: 0dB)Sending signals to internal/externaleffectsThis unit has two external effect sends (EFF 1 and EFF 2) and asend for the internal effects (INSERT EFFECT).You can adjust send levels for each track. For details about thebuilt-in send effects, see “Send effects” on page 53.Follow these procedures to enable use of these effects.1. Use the CURSOR (5/b/g/t) buttons to move the cursorto the SEND EFF 1/EFF 2 area.Effect sends2. Turn the JOG/DATA dial to enable the effect.Options: OFF (default), PRE, POSTPREThis sends the track pre-fader signal to the effect sendbus. The effect send signal level is not affected by the trackfader.POSTThis sends the track post-fader signal to the effect sendbus. The effect send signal level is affected by the trackfader.3. Use the SEND EFF 1/EFF 2 knobs to adjust the external sendlevels.Setting range: 0 to 127 (Default: 0)4. Use the SEND MASTER 1/MASTER 2 knobs to adjust theinternal send levels.Setting range: 0 to 127 (Default: 0)Enabling insert effectsThis unit has dynamic and guitar effects that can be used asinsert effects. For details about these effects, see “Dynamiceffects” on page 52 and “Guitar effects” on page 52.1. Use the CURSOR (5/b/g/t) buttons to move the cursorto the INSERT EFFECT area.Insert effectindicator2. Turn the JOG/DATA dial to enable/disable the insert effect.OptionsOFF: INSERT EFFECT indicator unlit (default)ON: INSERT EFFECT indicator lit