Tascam DP-32SD Owner's Manual

Also see for DP-32SD: Troubleshooting supplement Schematic diagram

Contents

TASCAM DP-32SD 539 - Using Internal EffectsAdjusting guitar effectsYou can edit the parameters of the selected guitar effect. Theparameters differ depending on the effect type.Press the F3 (SELECT) button to select the effect that you wantto edit.Use the CURSOR (5/b/g/t) buttons to select the parameterthat you want to change, and then use the JOG/DATA dial to setthe value.Select whether to apply the effect during recording or duringplayback with the POSITION parameter on the Guitar Effectscreen.Loading guitar effect settings1. On the Guitar Effect screen, press the F2 (LIBRARY) buttonto open the library list.2. Use the JOG/DATA dial to select the effect setting that youwant to load, and then press the F4 (t) button.3. The setting is loaded and the library list closes, but the GuitarEffect screen stays open.Press the F1 (g) button to return to the Guitar Effect screenwithout loading a setting.NOTEFactory preset settings are stored in the PRESET category, anduser settings are stored in the USER category.Saving guitar effects in the libraryYou can save adjusted effect settings as a user setting in thelibrary.1. When the Guitar Effect screen is open, press the F2(LIBRARY) button to open the PRESET/USER library list.Use the JOG/DATA dial to select the USER area, and thenpress the F3 (SAVE) button.NOTEThe library list has a PRESET category and a USER category.PRESET area data cannot be overwritten.2. Enter a name, if necessary.Names in the PRESET library cannot be changed.Send effectsThe internal send effect can be applied to signals sent to SendEffect 1.You can use one of the three types of send effects (REVERB,DELAY and CHORUS) available. You cannot use multiple types ofeffects simultaneously.Using send effectsYou can send input channel or track signals to the send effects.Set channel signal send levels and whether the signal is pre orpost fader on the Mixer screen. (See “Sending signals to internal/external effects” on page 36.)The return signal from this effect is sent to the stereo bus.In Bounce mode, however, it is sent to the bounce bus. (See“Bouncing tracks” on page 41.)Adjusting send effectsAdjust parameters on the EFFECT screen.Press the EFFECT button to open the EFFECT screen. If theGuitar Effect is shown, press the F1 (SEND) button to switch tothe Send Effect screen.Press the F3 (SELECT) button to select the effect type (REVERB,DELAY or CHORUS).Use the CURSOR (5/b/g/t) buttons to select the parameterthat you want to change, and then use the JOG/DATA dial to setthe value.Loading send effect settings1. On the Send Effect screen, press the F2 (LIBRARY) buttonto open the library list.2. Use the JOG/DATA dial to select the effect setting that youwant to load, and then press the F4 (t) button.3. The setting is loaded and the library list closes, but the SendEffect screen stays open.Press the F1 (g) button to return to the Send Effect screenwithout loading a setting.Saving send effects in the libraryYou can save adjusted effect settings as a user setting in thelibrary.1. When the Send Effect screen is open, press the F2(LIBRARY) button to open the PRESET/USER library list.Use the JOG/DATA dial to select the USER area, and thenpress the F3 (SAVE) button.NOTEThe library list has a PRESET category and a USER category.PRESET area data cannot be overwritten.2. Enter a name if necessary.Names in the PRESET library cannot be changed.