WAGO-I/O-SYSTEM 750 Commissioning 79750-494 3-Phase Power Measurement ModuleManualVersion 1.2.0Pos : 95 /All e Seri en (Allgemei ne Module)/Ü berschriften/Ebene 1/In Betri eb nehmen - Ü bersc hrift 1 @ 4\mod_1240901452750_21.doc x @ 31570 @ 1 @ 18 CommissioningPos : 96 /Serie 750 ( WAGO-I/O-SYST EM)/In Betrieb nehmen/Parametrier en mit WAGO- I/O-CH ECK/Parametrier en mit WAGO-I/O-CH ECK 750-0494 @ 15\mod_1367496874664_21.doc x @ 118340 @ 233333 @ 1The I/O module latched in the bus node and wired for the measurement can be putinto operation using the WAGO-I/O-CHECK software for Windows. For that, thefieldbus coupler/controller of the node is connected, for example, to the USB portof a PC using the WAGO USB communication cable.WAGO-I/O-CHECK provides the following functions:• Graphic display of the bus node• Display, recording and export of the process data (measured values)• Application settings• Settings for the measurements for each of the three phases• I/O module settings• Settings for saving the energy values• Saving all settingsWAGO-I/O-CHECKYou can obtain the WAGO-I/O-CHECK software on a CD under Item No. 759-302. This CD contains all the application program files and a description.The description is also available in the Internet at http://www.wago.com underDocumentation > WAGO Software > WAGO-I/O-CHECK.To display the bus node on the PC, use the USB communication cable to connectcoupler/controller and PC and launch WAGO-I/O-CHECK.