WAGO-I/O-SYSTEM 750 Commissioning 83750-494 3-Phase Power Measurement ModuleManualVersion 1.2.08.1.1 “Application“ TabMake application settings in the "Application" tab. These settings are not stored inthe I/O module, but on the connected PC.You specify again the decimal multiples for displaying the measuring units for thevarious measured variables or keep them:10-3 =milli or 100 =1 or 103 =kilo.In addition, you specify the storage path for the measured value records. See"Measurement Recording" in the following section "Displaying the MeasuredValues via WAGO-I/O-CHECK".Figure 22: „Application“ Tab