WAGO-I/O-SYSTEM 750 Commissioning 87750-494 3-Phase Power Measurement ModuleManualVersion 1.2.08.1.4 “Energy“ TabAfter entering a password, you can set or reset the energy values per phase on the"Energy" tab. The initial password is: wago. Please change this password on firstuse by clicking [Change password]. Should you have forgotten the passworddeinstall and install again the application “3-Pase Power Measurement”. This waythe initial password is valid again.The I/O module registers the energy consumption and saves the values cyclically.With [Save] and [Delete] you can save the values at any time regardless the cycleor reset them to 0.You can further set a specific value by choosing the energy from the list, enteringa value in milliwatt hours and [Save] it. The energy measurement starts at this setvalue.These actions are carried out immediately and cannot be undone. Therefore, the[Save] button is disabled at the bottom of the window.Figure 25: “Energy” Tab
