84 Commissioning WAGO-I/O-SYSTEM 750750-494 3-Phase Power Measurement ModuleManualVersion 1.2.08.1.2 "Phase L1”, “Phase L2”, “Phase L3” TabsUse the "Phase L1", "Phase L2", "Phase L3" tabs to configure user scaling, min.-/max. values and general parameters. These settings are saved to the I/O module.Figure 23: „Phase L1“ TabIn the event that you use current transformers to measure high currents, specify inuser scaling whether you want to take into account the current transformer ratioCTR when calculating the measured values in the respective phase or not. If yes,specify the divisor of the current transformer ratio D-CTR, e.g. "50 ". Register 32and 39 … 41 are written. For details, see section „Process Image“.