CONFIGURATION AND RESOURCE UTILITY (MVS)Creating a configuration fileEnter the following command to invoke the create configurationscreen:==> TSO EXEC ’XMRP.V1R2M1.CLIST(CRTCFGD)’To create a configuration file, enter the values or use the defaultfor each option shown on the screen. The value typed for NAMEOF CONFIG DESCRIPTION becomes the member name of theconfiguration file when it is saved in the XMRP.V1R2M1.CFGDLIBISPF library.The NON-SCS PRINT IMAGE options, NLSBOTH, NLS, TSI, andTSIBOTH, correspond to the following FSL Y27 of 0, 1, 2, 3,respectively.You can specify FSL commands not shown on the screen in auser-created FSL file. User-created FSLs should reside in a libraryseparate from the configuration descriptions. However, thelibrary attributes should be identical to the library,XMRP.V1R2M1.CFGDLIB ISPF. The utility provides a library,XMRP.V1R2M1.UCRTLIB, to store user created FSLs. Use theEDIT option of the ISPF primary option menu to perform thecreate and edit functions.The value typed for NAME OF USER-CREATED FSL correspondsto the location of the user-created FSL file. When theconfiguration file is saved, the user-created FSL is appended to it.If an invalid “User Created FSL” member is entered, an MVSUtility message is displayed:“LSCX504 WARNING ERRNO = ENFOUND GENERATED INFOPEN CALLED FROM LINE XXX OF UCRTOPEN (MAIN), OFFSET00005A PDS MEMBER NOT FOUND: XXXXXXXXINTERRUPTED WHILE: OPENING FILE ”ddn:UCRT”Press the key to return to the MVS utility screen, whichdisplays the message:“. . . . . data set not available”Key in a valid data set and member name. Press tosave the configuration description.CAUTION: If the user-created FSL needs to be modified aftercreating the configuration file, the configuration file does notreflect the changes made in the user-created FSL until you modifythe configuration file. See the section in this chapter, “Modifyingand loading a configuration file.”In the next example, the member MYFSL is located in the libraryXMRP.V1R2M1.UCRTLIB.If you are not logged on to the account that owns the member,enter the FSL location as follows with single apostrophes:NAME OF USER-CREATED FSL = = => ’XMRP.V1R2M1.UCRTLIB(MYFSL)’XEROX MRP FAMILY COAX COMMAND REFERENCE 7-13
