DSC AND SCS DATA STREAM COMMANDSSet Line Density (SLD)2BC6nnldDefines the vertical space required for one print line (Lines PerInch or LPI) overriding those set at the control panel.2B Control sequence prefix of a Set Line DensitycommandC6 Command class for a Set Line Density commandnn Number of bytes in the command stringincluding the byte countValid values are 01 and 02.If nn equals 01, ld defaults to the value set at theprinter, except for the 3287 emulation, whichdefaults to 6 LPI.If nn equals 02, the ld parameter is used.ld Line density or the distance moved for a singleline of vertical spacing.Valid values for this parameter for each emulationand the correlation between LPI and the ldvalues are:00 = 6 LPI 3262, 3268, 3287, 3812, 4245,626209 = 8 LPI 3262, 3268, 3287, 3812, 4245,62620C = 6 LPI 3262, 3268, 3287, 3812, 4245,626212 = 4 LPI 3262, 3268, 3287, 3812, 626218 = 3 LPI 3262, 3268, 3287, 3812, 6262Remember An invalid value for nn or ld causes all emulations to use adefault of 6 LPI and an invalid SCS parameter check to occur.The exceptions to this are the 3262, 4245, and 6262 emulations,which use the previously defined LPI value.2-16 XEROX MRP FAMILY COAX COMMAND REFERENCE
