DSC AND SCS DATA STREAM COMMANDSSet Print Density (SPD)2BD2nn2900cpDefines the number of characters to print per horizontal inch(CPI) or characters per line (CPL).2B Control sequence prefix of a Set Print DensitycommandD2 Command class for Set Print Densitynn Number of bytes in a command string includingthe byte countValid nn are:02 = default value for CPI applies.04 = CPI is defined by cp.Any other values cause the default value of CPI,that is set at the printer, to be used and aninvalid SCS parameter check occurs.29 Control type for Set Print Density command00 One-byte number which must be X'00.'cp One-byte number expressed in hexadecimal thatspecifies a CPI value for the emulations asfollows:00 = 10 CPI 3812, 3268, 62620A = 10 CPI 3812, 3268, 62620C = 12 CPI 38120F = 15 CPI 381210 = 16.6 CPI 3812, 326811 = 17.1 CPI 3812, 3268Default = X'00.'An invalid cp parameter causes the CPI defaultto be set at the printer, and results in an invalidSCS parameter check.Font Titan 17M is equal to 16.67 characters perinch. The value of 16.67 is used when calculatingorientation.Refer to the “Y3—Set Default CPI” section of the “FunctionSelection via Line (FSL) commands” chapter for the FSL commandthat impacts this SCS command.XEROX MRP FAMILY COAX COMMAND REFERENCE 2-17
