DSC AND SCS DATA STREAM COMMANDSSet Horizontal Format (SHF)2BC1nnhhlmrmht...tnDefines the maximum number of characters per line, left margin,right margin, and horizontal tabs. It activates the auto new linefunction.2B Control sequence prefix of a Set HorizontalFormat commandC1 Command class for a Set Horizontal Formatcommandnn Number of bytes in a command including nn.Valid values are 01 to FF.If nn equals 01, the maximum print positiondefaults to the user selected value, the leftmargin defaults to column 1, the right margindefaults to MPP, and the tab values are cleared.These settings represent the printer default state.A value of X'00' causes a SCS parameter checkand default values to be installed.hh A one-byte number specifying the maximumhorizontal print position in characters per line.Valid values for hh are printer dependent.The 3812 emulation accepts a maximum value of:X'8C' (140 decimal) - when the CPI is 10X'A8' (168 decimal) - when the CPI is 12X'D2' (210 decimal) - when the CPI is 15X'DF' (223 decimal) - when the CPI is 17The 3268 emulation accepts maximum values ofX'84' (132) when 10 character per inch (CPI) isselected and X'DC' (220) when 16 CPI isselected.For all other emulations, the maximum value ofhh is X'84' (132) as these emulations supportonly 10 cpi.A value of X'00' causes the default value to beused.If the hh value is not valid, defaults for this andall other parameters are selected and a SCSparameter check occurs.The default value for MPP (hh) is set at theprinter.Continuing on next page2-14 XEROX MRP FAMILY COAX COMMAND REFERENCE
